ST 165 Wireless Protocol Detector

To detect signals the ST 165 scans a series of frequency ranges of the known transmission standards. The user can set up the detection threshold and the number of desired frequency bands.

Signals identification is performed on basis of analysis of detected signals time parameters.

AUTOMATIC MODE

This mode is intended for DRTD automatic detection when it exceeds the operation threshold set by user.

Signal data is logged.

Scheduled work is provided.

	1	Short names of digital data transmission standards chosen by user for the work. If the alarm threshold is execeed then  the background of the name is highlighted red.  9 – GSM 900  18- GSM 1800  3G- 3G (UMTS)  W- WI- WI (WLAN)  BT- BLUETOOTH  DT-DECT  2.4- devices, other than WLAN and BLUETOOTH, operating at 2.4-2.485  GHz range  (for example, wireless surveillance cameras, etc.).
	2	32-segmental indicator signal level meter.
	3	Signal level numerical value, dB.
	4	Names of digital data transmission standards

MANUAL MODE

In this mode  indication BASE STATION signals level is provided.

1

Change in time of signal level (TIME DIAGRAM)

LOG VIEW

This MODE is desined for viewing the log of events . 

Time of event, its duration, type of event, signal strength are displayed.

	1	Detected standard
	2	Threchold of ALARM
	3	Information on event
	4	Viewed event No./Amount of event s in the bank
	5	Viewed bank No./Amount of used banks

ADDITIONAL POSSIBILITIES

• Setting thefrequency UMTC according to the location directly by the user

• Built-in Relay (terminals on the external port). Extends the functionality of the ST 165 to remotely control Alarm indicators

• SPECIAL SOFTWARE "ST165 ANALYZER"

  

  The software is intended to:

• firmware updating via internet

• the ST 165 remote full control via PC 

• time graphic display of data and the results of operation of the ST 165